Digital caliper case

I used the "0.08mm Extra Fine" preset settings for the base and top cover, changing the following parameters:Layer height: 0.1mmIroning: Upper surfacesWall loops: 3Infill density: 10% or 12%Texture: Cubic Adaptive For the pins I used the "0.08mm Extra Fine" preset with 100% infill density and Wall Loops 2.I cut the rubber template (you can also use TPU 85A filament, 2 mm thick) with the "0.28 Extra Draft" preset, since excessive precision was not necessary. The use of foam rubber or TPU is not mandatory; I only used it to prevent the caliper and batteries from moving too much inside the case.The dimensional tolerances of the pins are designed to be able to position it interlockingly, without using glue. The case should be fine for almost all calipers on the market. To be safe, I have included the general dimensions of the caliper in the attached assembly diagram.