Digital Wolf

by Corp · Hueforge & Lithophane

3 Downloads

4 Likes

2 Makes

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm The Model is 200x200mm in size. You can change the size of X and Y but Z must remain the same.You may print at higher layer heights below the Min Depth of 0.48mmActual Depth is 2.3mm Filaments Used:PLA BambuLab Basic Red Transmission Distance: 4PLA BambuLab Basic Black Transmission Distance: 0.3PLA BambuLab Basic Blue Gray Transmission Distance: 3PLA BambuLab Basic Jade White Transmission Distance: 5This print uses 4 unique filaments. Substitute as needed. Swap Instructions:Start with RedAt layer #8 (0.72mm) swap to BlackAt layer #17 (1.44mm) swap to Blue GrayAt layer #20 (1.68mm) swap to Jade White for the rest.Boost MeGot a Boost to spare? Every little bit helps the motivation. Thank you!Membership