Thingiverse
DigitalEye
von Digital_Eye
24
Downloads
8
Likes
0
Makes
This adapter was designed to allow use of Cricut pens (Shown Below) with the Silhouette Cameo 3. It was reversed designed by comparing the Cricut pen and the Silhouette Cameo 3 Pens (the short little fat pens that come in a 24 pack).
Notes:
-Using the settings below it should print just fine.
-Open the door to the printer and put a fan in front of the opening, blowing into the opening.
-Make sure to dehydrate your PLA before using it, this helps immensely.
Notes:
-Using the settings below it should print just fine.
-Open the door to the printer and put a fan in front of the opening, blowing into the opening.
-Make sure to dehydrate your PLA before using it, this helps immensely.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
