Thingiverse
Digitelektro LNA case
by R1chae
4
Downloads
5
Likes
0
Makes
fits Digitelektros LNAs up to v1.1 :3
needs 4 self tapping m2 screws, at least 5mm long I guess.
I guess it also fits any other pcb with 34-35mm length and 21mm width, up to 1mm thick with sma ports on each end centered...
The hole for the dc connector is slightly offset on the v1.1. use DigitLNA_v1.1_CaseTop.stl for that.
DigitLNA_v1.x_CaseTopClosed.stl has no hole for the dc pin.
spin around the Tops for printing im too lazy
needs 4 self tapping m2 screws, at least 5mm long I guess.
I guess it also fits any other pcb with 34-35mm length and 21mm width, up to 1mm thick with sma ports on each end centered...
The hole for the dc connector is slightly offset on the v1.1. use DigitLNA_v1.1_CaseTop.stl for that.
DigitLNA_v1.x_CaseTopClosed.stl has no hole for the dc pin.
spin around the Tops for printing im too lazy
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
