Thingiverse
Dimension consistency test
von CaptainCode
12
Downloads
7
Likes
0
Makes
I made this test because i noticed that the height of my prints isn't exact anymore.
I first printed a common testcube. To find out at which point the issue occurs i made this. I noticed that the first step of the pyramid is a little lower than the others. By looking at the leadscrew of the z-axis i noticed that it is harder to turn the screw at this height. So my test helped me because it indicated where the inconsistency occurs.
This test exists also cylindrical. Check out the thing [3268341](https://www.thingiverse.com/thing:3268341)
I first printed a common testcube. To find out at which point the issue occurs i made this. I noticed that the first step of the pyramid is a little lower than the others. By looking at the leadscrew of the z-axis i noticed that it is harder to turn the screw at this height. So my test helped me because it indicated where the inconsistency occurs.
This test exists also cylindrical. Check out the thing [3268341](https://www.thingiverse.com/thing:3268341)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
