Dimensional Mosaic Spin Mount

Based on the Dimensional Mosaics created by @KingRichardDude After making a couple, a friend said it would be really cool if they could spin. Based on the A1 Size template he uses at 156.87mm, I came up with this design. It has been a hit with friends an family and adds a little fun to the logos when you wear them to events. The Inside diameter is 158.439mm to leave some room for the logo. To Assemble i found it easiest to slide from the side under 2 tabs first. Then when it hits the back edge you can push down to snap it in to the final tab.You could certainly scale these up for the other sizes if needed. The large sizes being 175mm but only scale the X and Y Dimensions. Scaling Z will increase the gap to the mosaic edge. For 175mm to fit. 111.17% X & Y or 187.5mm x 187.5mm gives an inside diameter of 176.13mmThere is a small dot in the middle to reduce friction for spinning.3mf has supports for the tab lips. not 100% require, but remember to remove before trying to assemble. Boost Me