Thingiverse
Dimmable LED softbox
por thenickdude
846
Descargas
629
Likes
0
Makes
Light up your desk with this dimmable LED softbox! With 3D printed diffuser and honeycomb light shaper.
Powered by a LiPo battery (4S-7S) with an XT-60 connector. It has rails on the bottom for adding mounts and accessories!
Designed to fit on the Prusa i3's bed: a 250mm by 210mm build area is required for best results.
A 240x200mm bed is okay if you don't need to print the honeycomb light modifier, or if you remove its two little handles.
A 210x130mm bed is okay if you don't want to print either the diffuser or the light modifier. You can make a diffuser using baking paper stretched over a cardboard frame instead, or design a diffuser that can be printed in two pieces.
Note: Slicing instructions are based on [Slicer PE 1.42-alpha3](https://shop.prusa3d.com/forum/general-discussion-announcements-and-releases-f61/slic3r-prusa-edition-1-42-0-alpha3-t27105.html)
Powered by a LiPo battery (4S-7S) with an XT-60 connector. It has rails on the bottom for adding mounts and accessories!
Designed to fit on the Prusa i3's bed: a 250mm by 210mm build area is required for best results.
A 240x200mm bed is okay if you don't need to print the honeycomb light modifier, or if you remove its two little handles.
A 210x130mm bed is okay if you don't want to print either the diffuser or the light modifier. You can make a diffuser using baking paper stretched over a cardboard frame instead, or design a diffuser that can be printed in two pieces.
Note: Slicing instructions are based on [Slicer PE 1.42-alpha3](https://shop.prusa3d.com/forum/general-discussion-announcements-and-releases-f61/slic3r-prusa-edition-1-42-0-alpha3-t27105.html)
thenickdude también publica en
36 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
