Thingiverse
Dingus / Maxwell the cat 3D printer accessory
by TheMissile
1
Downloads
4
Likes
0
Makes
Made an account just to post this.
This is a printer accessory for the up-down screw of your printer (Idk what it's called).
The tube should be about 8mm wide on the inside for an Ender 3 v2 neo, you might want to make it a bit smaller, since 8mm is a bit lose (7mm is too small).
.blend files:
dingus on a stick.blend - cat with tube NOT MERGED
dingus on a stick2.blend - cat with tube MERGED
Printed on an Ender 3 v2 neo
This is a printer accessory for the up-down screw of your printer (Idk what it's called).
The tube should be about 8mm wide on the inside for an Ender 3 v2 neo, you might want to make it a bit smaller, since 8mm is a bit lose (7mm is too small).
.blend files:
dingus on a stick.blend - cat with tube NOT MERGED
dingus on a stick2.blend - cat with tube MERGED
Printed on an Ender 3 v2 neo
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!