DINGUS / MAXWELL THE CAT 3D PRINTER ACCESSORY

Made an account just to post this.
This is a printer accessory for the up-down screw of your printer (Idk what it's called).
The original file did not have a tube attached so I added it.
The tube should be about 8mm wide on the inside for an Ender 3 v2 neo, you might want to make it a bit smaller, since 8mm is a bit lose (7mm is too small).

.blend files:
dingus on a stick.blend - cat with tube NOT MERGED
dingus on a stick2.blend - cat with tube MERGED

Printed on an Ender 3 v2 neo