Dino Desk Risers

These cute little dinosaurs will hold up your monitor! The lift face is about 6.5cm, and the final height of the riser will be that in addition to the thickness of your board.Construction:The saved print profile will first print 8 sets of teeth, and then the 4 dino bodies. There are grooves in the dino mouths that the teeth should slide into place without difficulty, but tight enough that they do not need to be glued. You may need to shave down the sides slightly depending on how your print comes out, but I havent needed to for any of mine.Each dino should have 2 sets of teeth, 1 upper and one lower (despite 4 teeth grooves per mouth). Note that the inside of the teeth will line up with the edge of the board at each dino's respective position. You will want to have two dinos with teeth on the right side, and two with teeth on the left. The dinosaurs need to be attached to a wooden board or shelf at each corner as shown in the pictures. There is a tapered hole under the chin of each