Dino X-Ray

An x-ray of a dinosaur. Print at 100% infill with a layer height of 0.2mm with a base layer of 0.32mm Use any colors you'd like, either via AMS or by manually swapping filaments as indicated below. Filaments Used:PLA BambuLab Matte Charcoal Transmission Distance: 0.8PLA SPARKLE BambuLab Slate Gray Sparkle Transmission Distance: 3PLA BambuLab Matte Ash Gray Transmission Distance: 10PLA BambuLab Basic Jade White Transmission Distance: 3 Swap Instructions:Start with CharcoalAt layer #3 (0.72mm) swa