Dioder clamps

Looking for a way to mount the dioder LED strips of Ikea inside my Ultimaker Original, I came across the design of Martijndewinter. When printed, I noticed that the small notches of the clamps where not properly designed for some of the 4 clamps, actually they where not attached to the main part. Next to that, I was not very satisfied with the way I had to mount the LED strips on the Ultimaker.
So, based on Martijn's design, I created 2 new clamps. One to mount the dioder strip on the left and right top side (this is different from other designs I found on Thingiverse), and one to mount the strip inside the left and right corner of the front panel (which is an improved version of Martijn's design).
There is one drawback: the top lights are partly shaded by the belt. However, due to the different angles of the 4 led strips, you will still have plenty of light on the print in progress.