Dipole mounting case for antenna

With this mounting case (30x60x20 mm) you will have a dipole antenna up and runnig in just a couple of minutes. The case is designed for a BNC-connector and includes a pull relief for wires with an outer diameter (including isolator if applicable) of approx. 2,5 mm.

In addition to the printed parts you will need 8 self-tapping screws with a diameter of 3 mm and a length of about 9 mm.

If you are looking for clamps to mount the wire ends you might also want to check my wire end connectors (http://www.thingiverse.com/thing:1294612).

Amendment April 2018: I added an alternative top which is designed to be plugged on top of a 25 mm rod. I use such aluminum rods for mounting antennas and with this part it is very easy to erect dipole and inverted-V antennas.