Slicer Discord
Disappear_ball_magic – Modelo 3D imprimible de Thingiverse Thingiverse

Disappear_ball_magic

por yorim
39 Descargas
24 Likes
0 Makes
Ver Modelo
This is a magic trick from the 80's
it plays like this:
you open the cover to reveal the ball
the you take out the ball and put it in your pocket
then close the cover
say your preferred magic words like "abbrra ca dabra"
then open the cover again to show that the ball
was transferred from your pocket back to the little vase.
taddamm!!!

instructions for building
after printing all the parts
use some glue (i used epoxy) to connect the half ball
to the secret compartment.

good luck!

Enjoy !
Fuente
Thingiverse
Lo que necesitas para imprimir: Intermedio Baja confianza
¿Por qué?
impresión grande
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 2/3
Postproceso 1/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA
Cama mín.
200 mm (Grande)
Postprocesado
Pegado
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección