Disc Golf Holder Rack

Designed this because the others I found online bolted to a wall, and I wanted something that sat on a shelf.

The part is used for left, right, and middle, just print 2 of them. For longer spans, you'll need another one in the middle...I don't know what that point is.


Other parts needed -

Schedule 40 PVD pipe, 3/4" diameter (1 1/16" OD), what length you want
Pipe foam insulation
qty (4) M4 nuts
qty (4) M4 x 50mm L bolts


I have a 22" gap as that's the length of the insulation I had at the time, and that 22" fit 40 discs well (mostly drivers, would be less with taller-standing discs).

I printed in PLA, 3 walls, 35% infill, on a 0.5mm nozzle at .25 layer height. Should work fine for a 0.4/.20 setup. Don't go too burly with it as the part needs to flex a bit to clamp down on the pipe.