Thingiverse
Hobby
Zum Modell
Disc Golf Trophy
314
Downloads
217
Likes
6
Makes
Base file does not include the lettering shown in the picture. I will not be including a separate plaque file since the sizing can vary too much depending on what you choose to include.
Can be scaled up or down to fit your printer.
No supports required.
Top part should be printed upside down.
Pieces are glued together. I used 2-part plastic epoxy.
Can be scaled up or down to fit your printer.
No supports required.
Top part should be printed upside down.
Pieces are glued together. I used 2-part plastic epoxy.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
