Thingiverse
Discotehk maker coin
door Discotehk
5
Downloads
5
Likes
0
Makes
Maker Coin! All three parts have a .3mm gap so they should spin independently of each other if your printer has the tolerance for it. Made it while learning the absolute basics of Fusion 360.
Turned the middle ring into a fidget spinner because I was bored. https://www.thingiverse.com/thing:4565081
.2mm layer height.
Turned the middle ring into a fidget spinner because I was bored. https://www.thingiverse.com/thing:4565081
.2mm layer height.
Discotehk publiceert ook op
20 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
