Slicer Discord
Dish scrubber holder – 3D printable model from Thingiverse Thingiverse

Dish scrubber holder

92 Downloads
77 Likes
1 Makes
Go to Model
We used to keep our kitchen scrubber in a shallow dish next to the sink. My wife didn't like how it could sit in a little puddle of water if it hadn't been wrung out thoroughly, so she swapped out the dish for a binder clip. I absolutely despise the binder clip. It worked great for standing up the scrubber and letting water drain out of it, but it was a pain to put on and I was just opposed to the general idea of a binder clip as a sponge holder.

Printer to the rescue! This little dish sets the kitchen scrubber above the bottom of the dish so water can drop down into the tray, letting the scrubber dry and avoid growing nasty bacteria. If there's considerable drippage, the honeycomb patterned shelf lifts off and the tray can be poured out and/or cleaned.

This may serve well as a soap tray, too. Let your domestic imagination run wild and be sure to share by posting your make.
Source
Thingiverse
What you need to print this: Beginner Low confidence
Single piece
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 0/3
Printer
FDM / FFF
File format
STL
Material
ABS
Software
Cura, PrusaSlicer, or similar
Same designer, more platforms

mikeymakesit also publishes on

76 additional models across 3 more platforms

Verified by matching model titles across platforms.
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection