Dishonored Inspired Folding Sword

requires M3 bolts for assembly. Includes 3 blade variants, segmented for printing on smaller print beds, whole for the solid blade look, and notched for the solid blade as well as the extra tabs to break up the lines a bit.
1 25mm M3 Bolt
2 8mm M3 Bolts
3 M3 nuts
Place the Guard over the Grip and the Blade inside the Grip, use long bolt to mount the blade.
Put one of the nuts on the inside of the Cover hole on both sides, and push the Cover into the Grip, bolt in from the outside using the short bolts.
Tighten bolts to the point where joints spin with no resistance, glue or Loctite nuts so they don't back out.

if using the segmented or notched blade variant, glue in the tabs on the corresponding spot on the blade (to avoid surface fogging, use epoxy rather than super glue)

Best printed in Silk PLA but anything will do, this is fairly robust!