Dishwasher Leg / Foot Extensions

A quick design to raise a dishwasher to match a new countertop. Was previously resting on 1x1 wooden blocks. Printed in PETG, assuming the temperature under the dishwasher will get to around 50-60C for long cycles, PLA would not be adviseable. Used PLA as the interface with AMS, to aid in support removal. Hex is Keyed at 0.750 with a thickness of 0.310 and fit the feet perfectly of the whirlpool dishwasher. On install, I hot glued the rear legs to prevent them from moving when sliding it back in, this is optional.