Disney World Magic Band Reader Stand

This isn't a remix, but I wanted to be sure to link to the magic band reader i made this for.

I printed the Disney World Magic Band Reader V2 - 4460759, I just needed a little stand for it.

I'm not doing the full blown electronics in it, just and LED light string. You will see at the bottom of the stand there is a hole for the power cord in the back. There is a very small window in the front in case your LED light strip (if used) has a remote sensor. You could then affix the remote sensor at the little window so it can get the signal from the remote.

This stand is 2 pieces. the main stand (which is hollow all the way up to accommodate power cords if you want to do that. the other piece is a cap for the stand that you glue inside the sphere once its assembled. that keeps the stand right where it needs to be and nice and sturdy. there is a smaller hole in the cap to still allow the wiring to pass through.

Thanks!