Display wall mount flat for Vesa 100

by Fabrion365 · Electronics

717 Downloads

147 Likes

426 Makes

Vesa 100 (holes are 100mm apart) mount, to mount a display flat to the wall.Just attach one side to the display, the other to the wall and then slot them together.Very easy to print, no supports needed.The part on my pictures is just in two colors, as I run out of filament. Files/Build Plates:wall side with countersunk holes for screws up to 4mmwall side with countersunk holes for screws up to 5mmwall side with holes for flathead screws up to 4,5mm and a bit of wiggle roomdisplay side for M4 screws (most common)display side for M5 screwsspacer 5mm, if your Vesa mount is recessed Update:added a little center marker to the wall side, to make mounting easier