Thingiverse
Disposable Vape Battery Holder
von necrolingus
2
Downloads
3
Likes
0
Makes
Whenever I find a disposable vape I remove the battery and reuse it so it does not end up on a landfill. This little holder will protect the battery. It has a screw top and vent holes, as well as a little hole in case you want to run a JST or similar cable to it for charging.
It is suitable for batteries 37mm X 17mm in size.
These batteries range from 300mah up to 850mah and tend to have a lot of life left in them. They are perfect for powering led lights or low power IOT devices.
Print with 2mm layer height.
https://www.tinkercad.com/things/8x8wLQljLVF
It is suitable for batteries 37mm X 17mm in size.
These batteries range from 300mah up to 850mah and tend to have a lot of life left in them. They are perfect for powering led lights or low power IOT devices.
Print with 2mm layer height.
https://www.tinkercad.com/things/8x8wLQljLVF
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
