Thingiverse
Distech-Fan Mount
by 2phburns
9
Downloads
3
Likes
0
Makes
first draft of 40mm fan mount for Prometheus V2 hot-end.
8-21 added version with reduced 2.8mm hole size that shold hold the fan mounting screws without nuts.
Tested the design, https://youtu.be/In7PvJrPkE4 added some aluminum tape due to the proximity of the heater. During a half-hour print, the nozzle was fine.
8-21 added version with reduced 2.8mm hole size that shold hold the fan mounting screws without nuts.
Tested the design, https://youtu.be/In7PvJrPkE4 added some aluminum tape due to the proximity of the heater. During a half-hour print, the nozzle was fine.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!