Distilling / Brewing controller box

I got sick of cutting holes out of junction boxes from Home Depot so I decided to make my own with all the cutouts for all the components already in it. This is obviously a very specific configuration for me but figured there are probably others out there interested in this type of configuration. This is for a 240 volt controller so the incoming cable is 10/4 cable with associated cord grip that tightens into the hole. There are also countersunk holes to secure each component. There is a little wiggle room with the screw holes to move the components a small amount. The lid is secured with some custom screws you can tighten and loosen by hand. I never liked how you needed a screwdriver to take the lid off of regular junction boxes. The floor of the inside of the box has some wire organizers which helps everything look clean. List of components I used: https://a.co/d/2395nau terminal blockhttps://a.co/d/aBoBeYK volt amp meterhttps://a.co/d/4Wl3xB4 Fanhttps://a.co/d/cD5YOQN plughttps://a.