Slicer Discord
Divided Soap Holder for the corner – 3D-Druckmodell von MakerWorld MakerWorld
Other House Models

Divided Soap Holder for the corner

26 Downloads
11 Likes
17 Makes
Zum Modell
We can't mix face and body soap now, can we? Here's a divided soap holder/soap dish that accomplishes that. It's intended to fit in the corner of your shower or tub and can be attached with hardware store suction cups. I hope it adds just that tiny bit of joy to your zen time!The way I installed mine was to first clean the shower walls so the suction cups will stick better, then remove the wire hook from the suction cups. Slide one cup into each slot on the sides making sure to get them all the way in. I moistened the cups with a dab of water, then positioned it on the wall and pressed the sides where the suction cups are located. If it has trouble staying attached I may see if a thin smear of cooking oil will last longer—suction cups' staying ability is hit and miss sometimes. Failing that, I'll just position it all the way down so the bottom is supported by the top of the tub and the suction cups only need to hold it into the corner.
Kategorie
Other House Models
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

Tawpie veröffentlicht auch auf

3 zusätzliche Modelle auf 1 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen