Thingiverse
Diving Camera Tray for compact cameras
por honk3d
57
Descargas
47
Likes
0
Makes
This is an easy to print 5 part dive tray. You may attach lights with flex tubes to the handle bars if needed. I have joined the parts by inox screws for longer lasting parts. I used the tray for several salt water dives down to 43m / 140ft max depth. The tray did not pick up water and could withstand a test at land held at only one handle with camera + 2 lights attached.
The wider base makes the tray quite stable under water. So when filming you will have less shake.
What you need:
4x M6x25mm
4x M6 nuts
2x 6x60mm or 6x70mm (mounting the bars to the tray extensions)
several 6mm washers
2x rubber bicycle handle bar grips for 22mm bars
1-3x 1/4" UNC tripod mount screws, 15-20mm long (depending on your camera case)
optional for lights:
2x 5x50mm (mounting the pipe caps to the bars)
2x 3/4" pipe caps with 5mm hole drilled in center
2x 3/4" flex pipes / coolant pipes
2x 5mm washers
2x 22mm rubber washers to stop tubes from rotating in the cap
The lights seen in the pho
The wider base makes the tray quite stable under water. So when filming you will have less shake.
What you need:
4x M6x25mm
4x M6 nuts
2x 6x60mm or 6x70mm (mounting the bars to the tray extensions)
several 6mm washers
2x rubber bicycle handle bar grips for 22mm bars
1-3x 1/4" UNC tripod mount screws, 15-20mm long (depending on your camera case)
optional for lights:
2x 5x50mm (mounting the pipe caps to the bars)
2x 3/4" pipe caps with 5mm hole drilled in center
2x 3/4" flex pipes / coolant pipes
2x 5mm washers
2x 22mm rubber washers to stop tubes from rotating in the cap
The lights seen in the pho
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
