Thingiverse
Divoom Pixoo Stand Replacement
door Prophasi
4
Downloads
7
Likes
0
Makes
I bought the Divoom Pixoo (16x16) digital art frame device a while back for our daughter, and she loves it. However, after a while the head/hook on the little plastic stand broke and wouldn't work anymore, so I created this replacement.
As you can see in the photo, my original is broken entirely, so I didn't have an intact one to model it after and kind of winged the hook. Despite that, it seems to work pretty well. It stands the Pixoo up at a ~70-degree angle (not sure what angle the original stood at) and stows snugly into the dock on the back, so it shouldn't fall out. (It might seem a little too tight at first, but after a few placements it seemed about right.)
The only post-processing was removing the supports (in my case - probably not necessary in general) and a little work w/ flush cutters to remove burrs.
If you'd like a different angle, let me know and I'll try to upload some alternates.
As you can see in the photo, my original is broken entirely, so I didn't have an intact one to model it after and kind of winged the hook. Despite that, it seems to work pretty well. It stands the Pixoo up at a ~70-degree angle (not sure what angle the original stood at) and stows snugly into the dock on the back, so it shouldn't fall out. (It might seem a little too tight at first, but after a few placements it seemed about right.)
The only post-processing was removing the supports (in my case - probably not necessary in general) and a little work w/ flush cutters to remove burrs.
If you'd like a different angle, let me know and I'll try to upload some alternates.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
