Slicer Discord
DIY Ant Trap – 3D printable model from MakerWorld MakerWorld
Other House Models

DIY Ant Trap

317 Downloads
48 Likes
249 Makes
Go to Model
SummaryTo successfully kills ants using this device, you can use commercially available liquid ant poison or, make two batches of bait using boric acid which is cheap to purchase from the drug store. Type 1: mix 1/4 tsp of boric acid with1 tbs peanut butterType 2: mix 1/4 tsp of boric acid with 1 tbs jam/honey etc. Place a small portion of both baits in the trap, fasten the top and place the trap on the floor near the area you observe the ants entering the house. If you don't see where the ants are entering, place it near an outside door. The more the traps you have, the quicker the results. Check regularly to ensure you have bait in the trap. Leave it place for at least a week while the ants take the bait back to their nest. You should notice a difference within 2 to 3 days as the boric acid kills the ants in their nest. Boric Acid, (Not BORAX) which is a key ingredient in many store-purchased ant-bait products, can be inexpensively purchased as a powder at any reputable drug stor
Category
Other House Models
Source
MakerWorld
Published
Updated
What you need to print this: Beginner Low confidence
Single piece
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 0/3
Printer
FDM / FFF
File format
STL
Material
PLA
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection