Thingiverse
DIY Bird House
von muchin
2
Downloads
0
Likes
0
Makes
Simple Bird House
Printing:
0.2 mm
no support
50% infill about 42g in weight.
Cut and insert a 80-85mm diameter PVC pipe for the body (about 150mm long).
Glue the roof directly above the hole of the front part.
Insert the peg on the small opening of the front part.
Printing:
0.2 mm
no support
50% infill about 42g in weight.
Cut and insert a 80-85mm diameter PVC pipe for the body (about 150mm long).
Glue the roof directly above the hole of the front part.
Insert the peg on the small opening of the front part.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!