Thingiverse
DIY BrightDot tiara for Makers
von Whadda
15
Downloads
14
Likes
0
Makes
Be proud of the maker that you are and show it by making and wearing this colourful DIY tiara!
The tiara is 3D printed and fits 5 BrightDots and an ESP32 development board. The esp32 development board is pre-programmed with a rainbow sequence for up to 10 LEDs, so you don't need to program it! Unless of course, you want to mix it up and change the LED effect on the BrightDots. That's up to you! The BrightDots and the development board are Arduino compatible so you can try out something new either way.
It's an easy and fun project so give it your best shot and show us your creative skills!
Check out the tutorial on http://vellemanformakers.com
The tiara is 3D printed and fits 5 BrightDots and an ESP32 development board. The esp32 development board is pre-programmed with a rainbow sequence for up to 10 LEDs, so you don't need to program it! Unless of course, you want to mix it up and change the LED effect on the BrightDots. That's up to you! The BrightDots and the development board are Arduino compatible so you can try out something new either way.
It's an easy and fun project so give it your best shot and show us your creative skills!
Check out the tutorial on http://vellemanformakers.com
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
