DIY Digital Clock | Wemos D1 mini

🚨NEW (and better) MODEL🚨https://makerworld.com/en/models/1594116-espclock-digital-clock Here you can find Schematics and firmware!▶ https://github.com/telepath9/TM1637Clock ------- There are two ways to make it work: OFFLINE: using RTC module (no internet connection needed);ONLINE: Via wifi and receiving data from NTP servers;Have fun! How to printLayer width: 0.4Layer height: 0.3Perimeters (case): 3Supports (case): yesPerimeters (lid): 1Supports (lid): no What you needWEMOS D1 MINI (mine is V3.0.0)TM1637 module https://a.aliexpress.com/_EuPY34F(optional) RTC module DS1307 x9 M2.5x6 screws and x3 M2.5 nuts(optional) 12mm waterproof buttonA small piece of breadboardWires 🟥READ ME🟥Nuts should be embedded in the case, so remember to add a pause on your slicer, at the right layer (91 if you print with 0.3) , in order to put them in their spots! Because D1 mini has only 1 GND pin, and we need at least 2 GND pins, the solution i came up was to cut a piece of breadboard, drilling it, sold