DIY filament dryer

DIY filament dryer based on ECG SO 375 food dehydrator. There are two options for PTFE bowden tube mount:bowden-mount_lid.stl - not very convenientbowden-mount_base.stl - recommended, much betterYou will needECG SO 375 food dehydratorLamart LT6036 cake box51208 thrust ball bearing (inner diameter 40 mm, outer diameter 68 mm, height 19 mm)1/8" pneumatic fittingPTFE bowden tube (standard 4/2 mm)4× M3x8 screw + 4× M3 nut (when using bowden-mount_lid.stl)Print and assembly instructionsuse PETG for better heat resistanceprint 4-6 pcs of wall-adapter.stldrill a few holes in the top of the lid (two is enough)cut a hole in the lid for the bowden mount, 17 mm wide and 11 mm deep (when using bowden-mount_base.stl)