Thingiverse
Electronics
Go to Model
DIY Helping Hand Holder
155
Downloads
132
Likes
1
Makes
This easy to print DIY Helping Hand Holder will save you tons if your looking for a good quality third hand without buying the expensive bundles online.
Files included are the base unit and small rods to connect the pipes and alligator clips together. Once all the parts are printed the pipes should snap into the base unit holes. The alligator clips and pipe heads should fit snug onto the connector piece.
Link for the materials:
- Flexible Pipes ($5 CAD) https://www.amazon.ca/gp/product/B00BIZ7SDI/ref=oh_aui_detailpage_o03_s00?ie=UTF8&psc=1
- Alligator Clips ($3 CAD) https://www.amazon.ca/gp/product/B00GONY620/ref=oh_aui_detailpage_o01_s00?ie=UTF8&psc=1
Dimensions of the base = 219mm x 120mm x 20mm
Files included are the base unit and small rods to connect the pipes and alligator clips together. Once all the parts are printed the pipes should snap into the base unit holes. The alligator clips and pipe heads should fit snug onto the connector piece.
Link for the materials:
- Flexible Pipes ($5 CAD) https://www.amazon.ca/gp/product/B00BIZ7SDI/ref=oh_aui_detailpage_o03_s00?ie=UTF8&psc=1
- Alligator Clips ($3 CAD) https://www.amazon.ca/gp/product/B00GONY620/ref=oh_aui_detailpage_o01_s00?ie=UTF8&psc=1
Dimensions of the base = 219mm x 120mm x 20mm
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
