DIY LED tealight

DIY LED tealight with any color LED you want with voltage as close to 3V as possible. Uses 5 mm LED and CR2032 battery (3V). As this is designed to have as little hardware as possible and no soldering, there are no off switch and only way to turn it off is removing the battery. Diameter: 36 mmHeight: 19 mm (~36 mm with “flame” attached) Instructions: Bend the LED legs like this (right is the longer leg): These LED&#39;s have short legs (~18.5 mm & ~16.5 mm), cut shorter if needed. Insert the LED to the tealight: Add the ring with hole in center and bend the leg in the middle like this: Slide battery into the holder and push it on top of the LED aligning the open area with the side leg: Screw the cap on: Push the “flame” to the slot and you are done!<img src="https://makerworld.bblmw.com/makerworld/mode