Thingiverse
DIY Lego compatible Motor
por Daverolos
50
Descargas
35
Likes
0
Makes
This is a Housing for a small Motor (32,2x15x20,4mm without axle).
I used a ordinary BEC-Plug to connect the Motor with an Lego extension wire.
After Printing you have to cut a treat in the four little holes on the back of the Housing and assemble the housing with four M3 Screws.
I used a ordinary BEC-Plug to connect the Motor with an Lego extension wire.
After Printing you have to cut a treat in the four little holes on the back of the Housing and assemble the housing with four M3 Screws.
Daverolos también publica en
3 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!