DIY (Multicolor) lamp

I've designed a body for a DIY lamp in fuision360. ideal for the starting electronics hobbyist. The design consists of a lamp body with a screw ring to mount a (Plexi)glass sheet in place.

Please measure the needed diameter of this (plexi)glass after the print due to subtle differences in PLA shrinkage.

There is enough room inside for all kinds of electronics and LED strips. You might even want to use an ESP8266 or ESP32 to control your new light via your phone or a home automation controller.

If your thinking about doing that I can recommend the letscontrolit firmware, also known as easyesp.

Happy printing.