DIY small blinker switch

DIY small blinker switch for off-road bike with a 22mm handlebar.

Shopping List:
-Mini three way toggle switch ON-OFF-ON (you can choose the ones with autoreturning to off)(Voltage and amperage rating should be above the sum of the blinkers)
-4mm screws and nuts
-Small rubber dust cover

Instructions:
Print the 3D parts.
Disconnect battery and keep the bike off.
Solder the +12V wire from the battery or regulator to the center pin, left blinkers to RIGHT pin and right blinkers to LEFT pin.
Install the switch in the 3d printed part A and secure it with a nut. Test the switch if it works or you wired it backwards. I put electric tape and a little bit of hot glue to protect the connections.
Install the switch into the handlebar with the screws and nuts (you may have to cut them to lenght), install the rubber dust cover and put a drop of Super Glue into the hole of 3D printed part C and slide into the switch toggle (be careful with the glue flowing into the mechanism!)

Paint