Thingiverse
DIY switchable magnet
door greenail
107
Downloads
70
Likes
0
Makes
https://www.youtube.com/watch?v=YUt_nx_uZZ0
Switchable Magnet.
Center: 17.5mm turned down from .75" all thread
Outer bars: 3/8 (9.5mm)
Magnets: N42 10x5
This is a tad different than the design created by Andrew Klein. It is smaller, the outer "bars" go all the way through, and only the top magnets rotate.
Printed on cetus3d in PLA with 20% infil and .2mm layers
Switchable Magnet.
Center: 17.5mm turned down from .75" all thread
Outer bars: 3/8 (9.5mm)
Magnets: N42 10x5
This is a tad different than the design created by Andrew Klein. It is smaller, the outer "bars" go all the way through, and only the top magnets rotate.
Printed on cetus3d in PLA with 20% infil and .2mm layers
greenail publiceert ook op
1 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
