Thingiverse
DIY Tilt Sensor
von tanmayburde
3
Downloads
1
Likes
0
Makes
I used this for another project, and I wanted a told sensor without having to purchase a bunch that I may never use.
I modeled the holes but it is difficult to get correctly sized small holes so I used them mainly as a guide to drill holes.
I used a 6x3mm Neodymium magnet as the ball. I originally intended to use Aluminium foil, but found that it could be inconsistent and was prone to getting caught.
I used the following G-Code to pause the print to place the magnet inside:
G1 X50 Y200
M0
I modeled the holes but it is difficult to get correctly sized small holes so I used them mainly as a guide to drill holes.
I used a 6x3mm Neodymium magnet as the ball. I originally intended to use Aluminium foil, but found that it could be inconsistent and was prone to getting caught.
I used the following G-Code to pause the print to place the magnet inside:
G1 X50 Y200
M0
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
