Thingiverse
DJI Antenna Keeper
par Nisusfpv
9
Téléchargements
4
Likes
0
Makes
I got sick of my DJI air unit antennas breaking off inside of the air unit and then having to solder in a new antenna port. So, I designed the dji Antenna Keeper in Solidworks.
To install it on the air unit,
1.install the antennas
2.click the keeper in place over the antennas
3.slide the end hooks from the outside of the air unit toward the middle until it locks in place in the heat sink grooves on the top of the air unit. You may need to pull up on the keeper strap as you slide it over.
To install it on the air unit,
1.install the antennas
2.click the keeper in place over the antennas
3.slide the end hooks from the outside of the air unit toward the middle until it locks in place in the heat sink grooves on the top of the air unit. You may need to pull up on the keeper strap as you slide it over.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
