Thingiverse
DJI Camera Adaptor (Snap-fit)
por drewzh
16
Descargas
16
Likes
0
Makes
The original design didn't fit into my frame (GepRC KHX7) due to the protruding screws used to mount the camera. I also found that the print would split when the screws were tightened so I decided to try something different so I designed a snap-fit version.
Print in default orientation with supports to allow the layer lines to run the length of the snap-fit sections. This will ensure the wings can flex without breaking.
Print in default orientation with supports to allow the layer lines to run the length of the snap-fit sections. This will ensure the wings can flex without breaking.
drewzh también publica en
7 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
