DJI FPV Air Unit Case

This is an air unit "case" with antenna tubes out the back. The intent with this design was to allow easy non-permanent mounting in a quad/wing with built in antenna holders. I designed the case with the intent to slip shrink tube over the antenna holders and then install the antennas. Once the antennas are clipped in you can shrink the tube and "heat form" the angle to your preference.

I modeled the design around the proj 399 practice rig as it was a bit awkward to mount the 90deg antennas in this frame without worrying about abrasion against the top plate. This design should work in a multitude of different cases however. The current design is a 45 deg antenna angle (90 deg included angle between antennas). It could be easily modified to other angles if desired.

This design isnt perfect or final, if you have any comments or suggestions please feel free to leave me a comment and i'll take it into consideration. Thanks!


UPDATE: I added a 60 deg included angle version for th