Thingiverse
DJI FPV Analog Goggle Mod
von Pwnzorman
31
Downloads
34
Likes
0
Makes
I tried my hand at making an analog goggle mount for DJI FPV goggles. I wanted the mod to be able to take on and off easily for storage purposes. I also saw that most of the other files out are for V1 of the adapter board and not the V2. This model is for the V2 of the board, and that explains the cutout in the one side of the enclosure for the PCB and switch. This is the board I used https://www.racedayquads.com/products/analog-fpv-fatshark-module-adapter-for-dji-digital-fpv-goggles?variant=31203537453169 , it comes with necessary cables, just prints these parts and you're ready to go. The enclosure attaches on the right side of the goggles and quick slides in and out of the mount
The enclosure (and the rest of the parts) was/were designed to be printed without the need for supports and are already in the proper orientation for printing. Several pieces will need to be cut away from the enclosure (v support, power switch support, adapter board retention knob supports, and the overha
The enclosure (and the rest of the parts) was/were designed to be printed without the need for supports and are already in the proper orientation for printing. Several pieces will need to be cut away from the enclosure (v support, power switch support, adapter board retention knob supports, and the overha
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
