Thingiverse
DJI FPV HD camera mount
door evans036
17
Downloads
3
Likes
0
Makes
DJI FPV HD camera mount for 35mm front post width.
tilt is set at 30 degrees
this is the right hand side. you need to mirror for the left one (which you would normally do in your slicer software).
i can post an STL for the left if needed.
tilt is set at 30 degrees
this is the right hand side. you need to mirror for the left one (which you would normally do in your slicer software).
i can post an STL for the left if needed.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!