Slicer Discord
DJI Mavic Controller and iPad Holder – Modelo 3D imprimible de Thingiverse Thingiverse

DJI Mavic Controller and iPad Holder

264 Descargas
201 Likes
0 Makes
Ver Modelo
As great as the DJI Mavic drone is, the controller is designed to only hold a smart phone or a small tablet. I have the iPad Air 2 and the view is so much better that I wanted to use it instead of my iPhone. There are iPad holders on the market, but you need to hold them up and can’t easily use neck straps. Just the controller and iPad weigh almost two pounds and it gets heavy holding them out in front of you while flying. If you use a neck strap, it will block the iPad which defeats the whole point in using it.

This design solves these problems by using one part to hold the iPad and the controller and another part to guide and restrain the straps against your chest. Even if you let go of the controller, everything stays in place. Also the base part hooks over the lip under the controller display for more stability. There is a 10 degree back tilt on the iPad and controller for the optimum viewing angle. And you can use a sunshade on the iPad as long as it fits inside the G10 mount.
Fuente
Thingiverse
Lo que necesitas para imprimir: Principiante Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección