Thingiverse
DJI Mavic Pro Case
von izezti
112
Downloads
79
Likes
0
Makes
5mm thick case with slip fit lid and room to add felt liner if you so choose. Embossed DJI and engraved Mavic Pro.
To get a smooth top w/ the font and not deal with supports in the letters I printed this right side up w/ 3% supports... once the printing reached a Z height of 30.15mm I paused and added a layer of blue tape. You can of course just use a higher density of supports but I was being cheap with the filament and wanted to cut down time as much as possible! :) (vs. 15% supports would add 7 hours of print time and 90g of filament on 0.15 layer resolution)
To get a smooth top w/ the font and not deal with supports in the letters I printed this right side up w/ 3% supports... once the printing reached a Z height of 30.15mm I paused and added a layer of blue tape. You can of course just use a higher density of supports but I was being cheap with the filament and wanted to cut down time as much as possible! :) (vs. 15% supports would add 7 hours of print time and 90g of filament on 0.15 layer resolution)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
