DJI Mic magnet replacement

I lost the magnet that holds my DJI Mic 2 transmitter. It was $22 for a replacement and was out of stock. 3d printer to the rescue. Bill of materials14mm x 3mm (recommended) magnet OR 14 x 2mm magnet3d printer glue (optional but highly recommended)AssemblyPrint the top and bottomEnsure that it can close before proceedingSnug fit the magnet into place, orientation doesn't matterAdd a tiny drop of glue in the two grooves and a couple of tiny drops around the magnetCarefully close the lid and hold it firmly in place for about 10 seconds. Allow it to dry for a full minute before using.This should work for any DJI transmitter but I've only tested it on the Dji Mic 2. In theory, it should work on any microphone system since it's just a magnet.