DJI Mini Lightweight Clip-on Navigation Light LED Diffusers

https://youtube.com/shorts/rV_u_016a04

I had several aims when I started this but I didn't achieve all of them yet. I've ranked how happy I am so far with how close I was to achieving each :

* Lightweight : 9/10
* No need for supports : 9/10
* Easy to print : 5/10
* Does not obstruct folding the drone and not easy to accidentally pull it off : 7 / 10
* Easy clip on / off mini 2 : 3 / 10
* Easy to add / remove LEDs etc. : 4 / 10
* East to prepare electrical parts : 3 / 10 (i do not really know what I am doing with regards to crimping / soldering / etc,)

The printed plastic parts are approx 1.5 grams in ABS. Most of it is intended to be 1 wall thick at .4mm, except parts of the back clip and also some of the messy parts of the shoulder clips (all of it). I learnt blender to make this and redid each part many times so bits were made using different methods and are of different quality.

Print the back bit from the back of the clip and prnt the small diffusers on the 4