DJI OM4 magnet ring

DIY magnetic ring for DJI OM4 (might work for OM5 but not tested).
Use 3 pieces of 6x2mm neodym magnet.

THIS IS REALY IMPORTANT, TAKE YOUR TIME, BE CAREFULL OR IT WONT WORK:
-the 3 magnets have different orientation (thank you DJI).
-so before placing the magnet into the print hole, you must use the OM4 to check the orientation of each magnet.
-snap them to the OM4 head, they should naturaly take the good place and orientation.
-mark the visible face white a pen marker.
-put a drop of super glue in each hole.
-place each magnet accordingly into the 3 print hole (at this time be calm and use your brain to respect hole and orientation).
-You should get the correct magnet orientation.
-use superglue for the cover on top.

Depending on your print quality, a bit of sanding must be done to ensure correct snaping and placing onto the OM4.

Feel free to adapt.
Next step is to incorporate a magsafe ring magnet for iphone12 and up.
Printed in 0.2, no support.

https://youtu.